Amana washer repair
Amana Washer Repair in Mt. Lebanon & Upper St. Clair, PA
We test your Amana washer where it's installed in Mt Lebanon, Upper St Clair & Pleasant Hills, name the part that failed, and quote before any repair.
Rather type than call? Add the amana washer's model number and where you are in Mt Lebanon, Upper St Clair & Pleasant Hills, and we'll check parts before the visit.
Two quick steps: what's wrong and where you are. We'll be in touch to set a time.
Amana Washer Repair in Houses, Apartments and Rentals
Coverage here takes in ZIPs 15228, 15236, 15241, 15243. We work independently and aren't affiliated with Amana, so a unit still under the maker's warranty should go to Amana first. Keep the model number close by when you get in touch.
How a Washer Repair Visit Works
Describe the Problem
The brand, the model number if it's handy, and what the appliance is doing. A photo of the rating label is a bonus.
Diagnosis On Site
The technician tests the appliance and its power, water, drain, gas or vent until the failed part is found.
Explanation and Quote
You hear what failed and what the repair costs, then decide. Nothing starts without your OK.
Repair and Test
The part goes in, the appliance runs a cycle, and you see that it works before we leave.
Related Services
Other appliances, brands and places we cover.
Amana Washer Symptoms We Track Down
The same complaint can come from more than one part. We test on site to find which one before quoting.
- Not Spinning
- Not Draining
- Making Loud Noise
- Won't Start
- Leaking Water
- Not Filling with Water
- Door Won't Lock
- Vibrating Excessively
- Error Codes Displayed
- Not Agitating
- Clothes Not Getting Clean
- Washer Smells Bad
- Mold in Drum or Gasket
- Musty Odor Transferring to Clothes
- Door Gasket Mold
- Not Rinsing Properly
- Too Much Suds / Oversudsing
- Detergent Not Dispensing
- Fabric Softener Not Dispensing
- Bleach Dispenser Clogged
- Spin Cycle Stopping Early
- Not Completing Full Cycle
- Cycle Taking Too Long
- Pausing Mid-Cycle
- Filling Too Slowly
- Overfilling with Water
- Standing Water After Cycle
- Not Draining Completely
- Grinding Noise During Wash
- Banging Noise During Spin
- Squealing Noise
- Clicking Noise During Cycle
- Burning Smell from Washer
- Door Won't Open After Cycle
- Door Glass Cracked or Broken
- Door Seal / Gasket Torn or Damaged
- Leaking from Bottom
- Leaking from Door
- Leaking from Back of Washer
- Leaking from Detergent Drawer
- Drum Not Turning
- Agitator Not Working
- Agitator Dogs / Cogs Worn Out
- Drum Bearing Making Noise
- Drive Belt Broken
- Motor Failure
- Drain Pump Failure
- Water Inlet Valve Failure
- Lid Switch / Lock Failure
- Control Board Failure
- Water Temperature Wrong
- Washing Cold Only / No Hot Water
- Clothes Getting Damaged in Washer
- Tearing or Ripping Clothes
- Clothes Coming Out Tangled
- Soap Residue on Clothes
- Fabric Softener Spots on Clothes
- Rust Stains on Clothes
- Washer Won't Turn On
- Display / Control Panel Not Working
- Buttons Not Responding
- Pausing Randomly During Cycle
- Tripping Circuit Breaker
- Shaking the Floor During Spin
- Washer Moving Across Floor During Spin
- Not Balancing Load During Spin
- UE / Unbalance Error (LG)
- OE / Drain Error (LG)
- LE / Motor Error (LG)
- DE / Door Error (LG)
- 5E / SE Drain Error (Samsung)
- F21 Drain Error (Whirlpool)
- F5 / dL Lid Lock Error (Whirlpool / GE)
- Drum Bearing Replacement Needed
- Shock Absorbers Worn Out
- Spider Arm / Drum Support Broken
- Pump Filter Clogged
More Amana Products
About Amana washer repairs here
Amana washer repair in all 4 Mt Lebanon, Upper St Clair & Pleasant Hills ZIP codes: diagnosis in your home, then a price for you to accept before anything is done.
Mt. Lebanon is one of the region's classic suburbs, with brick houses from the 1920s to the 1950s tucked close together on curving streets, many with the garage cut into the basement. Upper St. Clair came later and has more room, and the boroughs along Route 51, from Pleasant Hills to Jefferson Hills, are largely postwar ranches and split-levels. Across all of them, the basement and the garage are where appliances have the hardest time.
On an Amana washer we check where the water goes out before where it comes in, and both before the motor and drive, since a washer that won't spin nearly always still has water it can't pump away, and a sock in the pump filter is a far likelier reason than a burned-out motor. Also worth knowing: Amana uses Whirlpool mechanics with simpler controls, so there's less electronics to fail and plenty of shared parts.
Call or book online and we'll set up a time that works for you.
Inside an Amana washer
Most Amana washers are Whirlpool-built top-loaders with an agitator and simple controls, and some older ones are the classic direct-drive design, where a small plastic-and-rubber coupler links the motor shaft to the transmission. That coupler is a deliberate weak point: it wears or breaks so the motor and transmission are spared, and a washer that takes water and pumps it out, yet never moves the clothes, often has a broken coupler. Newer Amana top-loaders use a lid lock and a shifter. Agitator dogs wear on dual-action agitators, leaving the top section limp. In a basement laundry, a laundry tub or standpipe that drains slowly makes the washer seem to fail, so the drain gets checked too.
One more point: because a new Amana is inexpensive, replacement starts to beat repair sooner than it would with a costlier brand.
Common Amana washer failures
What we look at first on this pairing: Motor coupler broken on direct-drive models; Lid switch or lock failing; Drain pump clogged; Agitator dogs worn; Shifter not changing modes.
That's where we start, not a verdict. The same complaint can come from an inexpensive part or a costly one, which is why the cause is confirmed in your home before any price is given.
Amana washers in Mt Lebanon, Upper St Clair & Pleasant Hills homes
In Mt Lebanon, Upper St Clair & Pleasant Hills' basements a washer often drains to a laundry tub or a floor drain that also carries groundwater in wet weather. When water appears on the floor, we work out which one it came from before blaming the machine.
A washer near a cold garage wall in Mt Lebanon, Upper St Clair & Pleasant Hills can have its supply freeze; braided hoses and a shutoff you can reach are cheap insurance.
The washer fault people misjudge
Across brands, the washer symptom that misleads people most is a code on the display treated as proof that some expensive part has died, when the washer is really just reporting a condition, like a load balled up on one side, a water tap only half open, or a drain hose shoved so far down the standpipe that it siphons.
In Mt Lebanon, Upper St Clair & Pleasant Hills, the local condition that matters most for a washer is basement machines emptying into old laundry tubs and floor drains, supply lines that freeze on cold outside walls, and damp concrete that rusts cabinets from underneath.
Cold garages and winter refrigerators
A refrigerator in an unheated space works on the edge of its design. In summer it runs constantly; in January it may hardly run at all, and a freezer that depends on the fresh-food thermostat thaws.
Before paying for a repair on a garage unit, check the manual's ambient-temperature range. We'll check it too, and tell you if the location is the actual problem.
Amana Washer in Mt Lebanon, Upper St Clair & Pleasant Hills, by the numbers
Amana Washer: Questions We Hear
Quick answers to what people ask most. If yours isn't here, bring it up on the phone or type it into the notes box when you book.
Something else on your mind?
Reach out with the brand, the symptom and a model number if you have one. Some questions we can answer on the spot; the rest a technician can check in person.
Not at all. Most repairs are done where the machine stands, and around Mt Lebanon, Upper St Clair & Pleasant Hills laundry is usually in the basement in Mt. Lebanon's older houses, and a basement or a first-floor laundry room in the newer houses of Upper St. Clair and Pleasant Hills. If the stairs are very narrow or steep, tell us when you book so we can plan for anything that might need to come out.
Many refrigerators and some freezers are designed for a heated room, and in an unheated Mt Lebanon, Upper St Clair & Pleasant Hills garage the controls may not run the compressor enough on the coldest days. The owner's manual lists the temperature range your model was built for. We'll check whether it's the location or a fault before quoting anything.
That depends on what broke. A switch, valve, pump or element is a small fraction of what a control board or sealed-system job runs; you get the figure once it's diagnosed and before any work.
Often, if we have the model number beforehand. Amana shares a parts bin with the other Whirlpool brands, so compatible parts are usually easy to get, even for older units. Parts that must be ordered come with a lead time you hear before deciding.
